40-Position Quick Change Tooling System (Toolpost, Multifix-type)

40-Position Quick Change Tooling System (Toolpost, Multifix-type)
40-Position Quick Change Tooling System (Toolpost, Multifix-type)
40-Position Quick Change Tooling System (Toolpost, Multifix-type)
40-Position Quick Change Tooling System (Toolpost, Multifix-type)
40-Position Quick Change Tooling System (Toolpost, Multifix-type)
40-Position Quick Change Tooling System (Toolpost, Multifix-type)

40-Position Quick Change Tooling System (Toolpost, Multifix-type)
Although the ad from Rutland says the toolpost is for 10-15 inch lathes, it was obviously too small for my 14-inch as the previous owner had installed a riser plate underneath it. I would recommend that this equipment be used on lathes 12-inches and smaller similar to an Aloris AXA. One(1) 40-position toolpost w/tightening wrench. One(1) Mounting stud (3/4-inch diameter, 16 tpi, approximately 6-inches long) and flange approximate dimensions 2.25 x 2.5 x 5/8 with two(2) 0.25 x 0.375 x 2.5 inch rabbets. Note: Does not include nut. Three(3) 3/4-inch capacity turning and facing holders. One(1) 3/4-inch capacity boring bar holder. One(1) Adjusting wrench for tightening the screws which mount tools in the tool holders. This equipment is used but in excellent, like new condition. Specifically excluded is the mounting nut and the ruler shown in one picture. For sale only in the USA. The item “40-Position Quick Change Tooling System (Toolpost, Multifix-type)” is in sale since Friday, February 14, 2020. This item is in the category “Business & Industrial\CNC, Metalworking & Manufacturing\Workholding & Toolholding\Toolholding\Quick Change Tool Post”. The seller is “jim_in_marin” and is located in Fairfax, California. This item can be shipped to United States.
  • Brand: Unbranded
  • Tool Post Type: Quick Change Tool Post

40-Position Quick Change Tooling System (Toolpost, Multifix-type)

Comments are closed.

Swiftray Theme Powered by WordPress