40 Position Quick Change Tool Post Ec Multifix, For Lathe WM210 150-250mm Swing

• May 3, 2024
• Posted in position
• By admin
• Comments Off

You may also like. 40 Position Quick Change Tool Post Ec Multifix, For Lathe WM210 150-250mm Swing. Quick Change Tool Post Set has 4 holders for lathes with a center height of no more than 125 mm(4.94?). Recommended top slide width :55-70mm. Adjustable turning tool height :15mm. Ec Model : S/N:01013, Hole diameter : 18mm. […]

40 Position Quick Change Tool Post Ec Multifix, For Lathe WM210 150-250mm Swing

• February 6, 2023
• Posted in position
• By admin
• Comments Off

The Ec/Ed tool holder is made specifically for the WM210v lathe. The tool holder is. 60mm (2.362) wide. Which is 10mm (0.393) wider than the Aa, which gives it better clamping capacity. There is a comparison chart below where you can see the difference between them. Quick Change Tool Post Set has 4 holders for […]